tag:blogger.com,1999:blog-6245413346375218188.post8013658937749375234..comments2024-03-15T05:42:04.481-07:00Comments on Nerd Ralph: GD32E230: a better STM32F0?Ralph Doncasterhttp://www.blogger.com/profile/00037504544742962130noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-6245413346375218188.post-12669014218462130962023-02-21T12:14:09.506-08:002023-02-21T12:14:09.506-08:00Yeah, I commented on Jay's blog post a couple ...Yeah, I commented on Jay's blog post a couple weeks ago, but it seems he hasn't approved it yet.Ralph Doncasterhttps://www.blogger.com/profile/00037504544742962130noreply@blogger.comtag:blogger.com,1999:blog-6245413346375218188.post-45311292557787344852023-02-21T11:05:51.539-08:002023-02-21T11:05:51.539-08:00Have you seen the new (ish) py32 MCU's? https:...Have you seen the new (ish) py32 MCU's? https://jaycarlson.net/2023/02/04/the-cheapest-flash-microcontroller-you-can-buy-is-actually-an-arm-cortex-m0/Bradhttps://www.blogger.com/profile/12438735384690328749noreply@blogger.comtag:blogger.com,1999:blog-6245413346375218188.post-15644292802449425522021-10-15T07:05:48.886-07:002021-10-15T07:05:48.886-07:00Can you please check if you get your device to res...Can you please check if you get your device to reset with the SYSRESETREQ bit? After observing some strange behavior (like peripherals not reset at the begin of a debug session with J-Link and Eclipse) and the inability to use the Pre-run reset.<br /><br />Then I tried to add a monitor command to directly write 0x5fa0004 into SCB->AIRCR and it had zero effect. Next I tried to do it from within my own code (to provoke a reset loop when it works) but the write is just ignored. Calling nvic_system_reset() will not work either, it will be stuck in an infinite loop, waiting for a reset that will never happen, it works neither during debug nor when free running.<br /><br />Berndhttps://www.blogger.com/profile/16821742864074773245noreply@blogger.com